XK (X100) V8-4.2L SC (2003)
/v8-4.2l_sc/Page-755001.png)
Trim Panel: Service and Repair
Pillar Trim
A-Pillar Trim Panel
Removal
1. Disconnect the battery ground cable.
2. Detach the 'A' post upper trim pad.
-
Remove and discard any damaged retaining clips.
3. Remove the 'A' post trim pad.
-
Disconnect the occupancy sensor electrical connector.
Installation
1. NOTE: Install new retaining clips if damaged.
To install, reverse the removal procedure.
2. Carry out the battery reconnection procedure.
