XK (X150) V8-4.2L (2008)
7. Loosen each of the two Torx T20 screws that hold the touchscreen to the plastic bezel one turn. (Figure 5)
NOTE:
The required gap between the screen and the bezel is 0.8mm (0.030 in)
8. Measure the gap between the screen and the bezel.
9. Applying light pressure to the screen (moving the unit rearward in the frame), tighten the four Torx T30 screws while holding the screen in position
10. Install the center stack assembly into the fascia. (Figure 6)
11. Position and tighten the four Torx T30 screws which clamp to the metal frame and the two Torx T20 screws which hold the center vent. (Figure 7)
12. Install the veneer trim.