XK (X150) V8-4.2L (2008)
Amplifier: Service and Repair
Amplifier (86.50.10)
Removal
1. Remove the instrument panel assembly.
NOTE: The component is situated in the passenger footwell. LHD is illustrated the procedure to remove the component on a RHD vehicle is
similar.
2. Remove the heater duct.
-
Remove the 2 Torx screws.
-
Release the lamp holder.
3. Carefully release the carpet for access.
CAUTION: Make sure the wiring harness and electrical connectors are not damaged during the carpet release.
4. Remove the subwoofer cover.
-
Remove the 4 bolts.
5. Disconnect the 2 electrical connectors.
-
Carefully disconnect the MOST connector.
CAUTION: Cover fibre optic cable connectors to minimize dust ingress and avoid bending the cables in a radius of less than 30 mm.
6. Remove the amplifier.
-
Remove the 4 Torx screws.
Installation
1. Install the amplifier.
2. Connect the electrical connectors.
-
Connect the MOST connector.
3. Install the subwoofer cover.
-
Tighten the bolts to 10 Nm (7 lb.ft).
4. Install the carpet.
CAUTION: Make sure the carpet is correctly installed and that no foul-condition exists when the accelerator pedal is depressed.
5. Install the heater duct.