XK (X150) V8-4.2L (2008)
Front Fender Liner: Service and Repair
Fender Splash Shield (76.10.90)
Removal
1. Disconnect the battery ground cable.
2. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
3. Remove the LH front wheel and tire.
4. Remove the fender splash shield, rear section.
-
Remove the 6 Torx bolts.
-
Remove the clip.
-
Remove the 2 nuts.
5. Remove the fender splash shield, front section.
-
Remove the 13 Torx bolts.
Installation
1. Install the fender splash shield, front section.
-
Tighten the Torx bolts.
2. Install the fender splash shield, rear section.
-
Tighten the Torx bolts.
-
Tighten the nuts.