XK (X150) V8-4.2L (2008)
/v8-4.2l/Page-1334003.png)
5. Spray the solution onto the area of paintwork. (Figure 3)
CAUTION:
Avoid touching the adhesive when dry, as this will leave a fingerprint in the film.
*Tip: Spray some solution onto your fore finger and thumb when peeling off the backing paper.
6. Peel back the part from the sheet whilst continuously spraying the solution onto the adhesive side of the film (making sure the adhesive is fully
saturated). (Figure 4)
CAUTION:
Do not go over the radius or the film may lift at the edge.
