XK (X150) V8-4.2L (2008)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
Removal
NOTE: The ABS Module is part of the hydraulic control unit (HCU) and cannot be serviced separately.
1. Remove the HCU.
Installation
1. Install the HCU.
Front Wheel Speed Sensor
Removal
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the LH front wheel.
3. Release the front of the fender splash shield.
> Remove the 11 Torx bolts.
> Tie the splash shield aside.
4. Remove the wheel speed sensor.
> Remove the retaining clip.
> Carefully release the 4 clips.
> Disconnect the electrical connector.
Installation
1. Install the wheel speed sensor.
> Install the retaining clip.
> Carefully secure the clips.
> Connect and secure the electrical connector.
2. Install the fender splash shield.
> Tighten the Torx bolts.