XK (X150) V8-4.2L (2008)
Brake Switch (Cruise Control): Service and Repair
Speed Control Deactivator Switch (19.75.20)
Removal
NOTE: This component also functions as the brake pedal switch.
1. Remove the driver's side footwell trim panel.
-
Carefully release the 3 clips.
CAUTION: Removal of the clips is a delicate procedure, damage will occur if any force is used.
2. Release the brake switch.
-
Rotate clockwise approximately 30 degrees.
-
Carefully release the clip.
-
Disconnect the electrical connector.
Installation
1. Install the brake switch.
-
Connect the electrical connector.
-
Secure the clip.
2. Install the driver's side footwell trim panel.
-
Carefully align and secure the clips.