XK (X150) V8-4.2L (2008)
Crankshaft Main Bearing Seal: Service and Repair
Crankshaft Rear Seal
Special Service Tools
Removal
1. Disconnect the battery ground cable.
2. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
3. Remove the torque converter flexplate.
4. Install the special tools.
> Install the 2 bolts.
> Tighten the 2 nuts to retain the special tool.
5. Using the special tool, pierce the seal to create holes for the 6 self-tapping screws.
6. Using the special tools, remove and discard the crankshaft rear oil seal.
> Install the 6 self-tapping screws.
> Adjust the 2 nuts.
> Tighten the center bolt.