XK (X150) V8-4.2L (2008)
/v8-4.2l/Page-1396002.png)
^
Remove the 2 nuts.
^
Disconnect the 2 electrical connectors.
Installation
1. Install the tire pressure monitoring module.
Tighten the nuts to 10 Nm (7 lb.ft).
Connect the electrical connectors.
2. Secure the auxiliary junction box mounting bracket.
^
Tighten the nuts to 10 Nm (7 lb.ft).
3. Install the rear seat RH backrest retaining bracket.
^
Tighten the nuts and bolts to 10 Nm (7 lb.ft).
4. Install the RH roll over protection unit.
^
Tighten the Torx bolts to 25 Nm (18 lb.ft).
^
Connect the electrical connector.
5. Install the LH roll over protection unit.
6. Connect the battery ground cable and install the cover.
7. Using WIDS, configure a new module.
