XK (X150) V8-4.2L (2008)
Center Mounted Brake Lamp: Service and Repair
High Mounted Stoplamp (86.41.01)
Removal
1. Remove the liftgate lower trim panel.
2. Disconnect the high mounted stoplamp electrical connector.
3. Remove the high mounted stoplamp.
-
Carefully release the Torx bolt covers.
-
Remove the 2 Torx bolts.
Installation
1. Install the high mounted stoplamp.
-
Tighten the Torx bolts to 6 Nm (4 lb.ft).
-
Install the Torx bolt covers.
2. Connect the high mounted stoplamp electrical connector.
3. Install the liftgate lower trim panel.