XK (X150) V8-4.2L (2008)
Oil Temperature Sensor For ECM: Service and Repair
Oil Temperature Sensor (18.31.01)
Removal
1. Remove the cover and disconnect the battery ground cable.
2. Raise and support the vehicle.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
3. Remove the engine undershield.
4. Remove the oil temperature sensor.
-
Disconnect the electrical connector.
Installation
1. Install the oil temperature sensor.
-
Clean the components.
-
Apply sealant of the correct specification to the sensor thread.
-
Tighten the sensor to 15 Nm (11 lb.ft).
-
Connect the electrical connector.
2. Install the engine undershield.
3. Connect the battery ground cable and install the cover.