XK (X150) V8-4.2L (2008)
Keyless Start Control Module: Service and Repair
Start Control Unit
Removal
1. Remove the rear seat armrest.
2. Remove the floor console veneer trim panel.
3. Remove the floor console rear panel.
-
Carefully release the 2 clips.
4. Remove the floor console side panel trim.
-
Remove the 2 Torx bolts.
-
Carefully release 11 clips.
-
Repeat the procedure and remove the opposite hand.
5. Remove the keyless start control module trim cover.
-
Remove the 2 Torx screws.
6. Remove the keyless start control module.
-
Remove the 2 Torx screws.
-
Disconnect the electrical connector.
Installation