XK (X150) V8-4.2L (2008)
Front Steering Knuckle: Service and Repair
Wheel Knuckle
Special Service Tools
Removal
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the hub assembly.
3. Remove the brake disc shield.
> Remove the 3 rivets.
4. NOTE: Use an additional wrench to prevent the component from rotating.
Disconnect the steering gear tie rod end ball joint.
> Remove and discard the tie rod end retaining nut.
5. NOTE: Use an additional wrench to prevent the ball joint rotating.
Disconnect the upper arm from the wheel knuckle.
> Remove and discard the nut.