XK (X150) V8-4.2L (2008)
13. Release the engine compartment LH side wall.
-
Remove the 4 bolts.
14. Remove the windshield wiper motor.
-
Disconnect the electrical connector.
-
Remove the 3 bolts.
Installation
1. Install the windshield wiper motor.
-
Tighten the bolts to 10 Nm (7 lb.ft).
-
Connect and secure the electrical connector.
2. Install the engine compartment LH side wall.
-
Tighten the bolts to 6 Nm (4 lb.ft).
3. Align and install the wiring harness grommet.
4. Install the ECM.
-
Tighten the bolts to 10 Nm (7 lb.ft).
-
Connect the ECM electrical connectors.
5. Connect the ground cable.
-
Tighten the nut to 10 Nm (7 lb.ft).
6. Install the electrical connector.
-
Tighten the Torx screws.
7. Connect and secure the electrical connector.
-
Tighten the center bolt.
8. Position and install the power distribution box.
-
Tighten the Torx bolts to 8 Nm (6 lb.ft).
9. Install the secondary bulkhead panel.
-
Carefully secure the clips.
-
Tighten the nut to 4 Nm (3 lb.ft).
10. Connect the brake booster vacuum hoses.
-
Position and secure the grommet.
11. Install the engine compartment braces.
-
Tighten the Torx bolts to 25 Nm (18 lb.ft).
-
Install the grommet.
-
Repeat the above procedure for the other side.
12. Fill the A/C system.
13. Remove the plenum chamber panel.
14. Connect the battery ground cable and install the cover.