XK (X150) V8-42L SC (2007) Rocker Panel Stone Chipping Issue
7. Gently lay the film onto the panel aligning the top corner, the film should be 2mm in from the radius of the vertical edge and 2mm down from the
radius of the top edge.
(Figure 5)
CAUTION:
Take care not to trap any air or fluid as this will be visible particularly on dark vehicles.
8. Once the panel is positioned correctly, spray more solution on to the face of the film.
9. Using a suitable rocker panel protection kit film smoother, following the pattern of strokes: (Figure 6)
^
Use suitable pressure to remove any fluid and air bubbles, securing the film into place.
NOTE:
Some fluid residue cannot be removed.