XK (X150) V8-4.2L SC (2007)
Installation
1. Install the brake caliper anchor plate.
> Clean the component mating faces.
> Tighten the bolts to 115 Nm (85 lb.ft).
2. Install the LH brake pads.
> Secure the inboard brake pad in the clip.
> Position the outboard brake pad.
3. Install the LH brake caliper.
> Tighten the guide pins to 28 Nm (21 lb.ft).
> Install the access plugs.
4. Install the LH anti-rattle spring.
> Carefully secure the clips.
5. Connect the brake hose to the brake caliper.
> Install new sealing washers.
> Tighten the union to 35 Nm (26 lb.ft).
6. Install the front wheels and tires.
7. Bleed the brake system.
Performance Brakes
Brake Caliper - Vehicles With: High Performance Brakes
Special Service Tools
Removal
CAUTION: Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the front wheel and tire.
3. CAUTION: Always plug any open connections to prevent contamination.
NOTE: To prevent the loss of brake fluid, using the special tool apply the brake pedal and set to 40 mm 1.6 in below the rest position.