XK (X150) V8-42L SC (2007) Front Brake Rotor Service & Repair | Page 3071
Brake Rotor/Disc: Service and Repair
Rear
Brake Disc - Vehicles With: Standard Brakes
Removal
WARNING: Brake pads must be renewed in axle sets only. Failure to follow this instruction may result in braking efficiency being impaired.
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the rear brake pads.
3. Tie the brake caliper aside.
4. Remove the brake caliper anchor plate.
> Remove and discard the 2 bolts.
5. Remove the brake disc.
> Remove the 2 clips.
Installation
1. WARNING: Do not use compressed air to clean brake components. Dust from friction materials can be harmful if inhaled.
Install the brake disc.
> Clean the component mating faces.
> Secure the clips.
2. Install the brake caliper anchor plate.
> Clean the component mating faces.
> Tighten the bolts to 103 Nm (76 lb.ft).
3. Install the brake pads.