XK (X150) V8-4.2L SC (2007)
Valve Cover: Service and Repair
LH
Valve Cover LH
Removal
1. Remove the cover and disconnect the battery ground cable.
2. Remove the ignition coil-on-plug.
3. Remove the remaining ignition coil-on-plugs.
4. Remove the oil level indicator and tube.
> Remove the nut.
> Remove and discard the O-ring seal.
5. Release the clip and disconnect the purge inlet line.
6. Remove the engine cover bracket.
> Remove the 2 nuts.
> Position the bracket aside.
7. Release the 3 wiring harness clips.
8. Disconnect the variable camshaft timing ( VCT) oil solenoid electrical connector.