XK (X150) V8-4.2L SC (2007)
Installation
1. CAUTION: Do not lubricate the components.
Partially install the crankshaft rear oil seal.
> Make sure the components are clean and dry.
> Carefully remove the transit sleeve, leaving the seal on the crankshaft.
2. CAUTION: Make sure the seal is installed parallel
Using the special tool, install the crankshaft rear oil seal.
> Tighten the special tool nuts evenly and progressively to fully install the seal.
3. Install the torque converter flexplate.
4. Check and top-up the engine oil.
5. Connect the battery ground cable.