XK (X150) V8-4.2L SC (2007)
11. Disconnect the refrigerant lines from the A/C compressor.
-
Remove the 2 bolts.
-
Remove and discard the 2 O-ring seals.
CAUTION: Immediately cap all refrigerant lines to prevent ingress of dirt and moisture.
12. Remove the A/C compressor.
-
Disconnect the electrical connector.
Installation
1. Install the A/C compressor.
-
Tighten the bolts to 25 Nm (18 lb.ft).
-
Connect the electrical connector.
2. Connect the refrigerant lines.
-
Clean the component mating faces.
-
Install the new O-ring seals.
-
Tighten the bolts to 9 Nm (7 lb.ft).
CAUTION: Lubricate the new seals with clean refrigerant oil.
3. With assistance, install the A-frame.
-
Tighten the bolts to 55 Nm (40 lb.ft).
4. Install the LH engine mount.
5. Install the HO2S.
6. Remove the special tools.
7. Install the accessory drive belt.