XK (X150) V8-4.2L SC (2007)
License Plate Lamp: Customer Interest
Lighting - Trunk Lid License Plate Lamps Loose
NO: JTB00200
ISSUE: 2
DATE: 21 JAN 2011
ISSUE 2 CHANGES ARE HIGHLIGHTED IN GRAY AND SHOWN WITH ASTERISKS.
SECTION: 501
Trunk Lid Finisher License Plate Lamps Loose
AFFECTED VEHICLE RANGE:
XK (X150)
VIN: B00001 - B37418
Model Year: 2007 - 2010
CONDITION SUMMARY:
Situation:
The rear license plate lamp(s) may become loose or dislodged from the trunk lid finisher. This may be caused by poor material durability to KATS
remover or other environmental factors.
*NOTE:
Perform the Repair Procedure only if a push-fit number plate lamp does not remain in place. A new trunk lid finisher and two new screw-fit lamps must
be installed to affect a robust repair.*
Action:
In the event of a customer concern of the above, refer to the Repair Procedure outlined below to replace the number plate lamps and luggage
compartment lid finisher.
PARTS INFORMATION
TOOLS:
Refer to Workshop Manual for any required special tools
WARRANTY:
NOTE:
Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always refer
to DDW to obtain the latest repair time.
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.