XK (X150) V8-4.2L SC (2007)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position (CKP) Sensor (18.30.12)
Removal
1. Remove the cover and disconnect the battery ground cable.
2. Raise and support the vehicle.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
3. Remove the crankshaft position (CKP) sensor.
-
Disconnect the electrical connector.
-
Remove the Torx screw.
NOTE: Clean the components general area prior to dismantling.
Installation
1. Install the CKP sensor.
-
Clean the component mating faces.
-
Tighten the Torx screw to 8 Nm (6 lb.ft).
-
Connect the electrical connector.
2. Connect the battery ground cable and install the cover.