XK (X150) V8-4.2L SC (2007)
^
Connect the electrical connector. (Figure 3)
^
Release the splash shield.
^
Install the five Torx bolts removed from the rear lower edge of the rear fender splash shield. (Figure 2)
^
Install the removed wheel and tire.
^
Lower the vehicle.
^
Install the fuel filler door to the hinge arm. (Figure 1)
^
Refer to GTR Workshop Manual Section 414-01 and connect the battery ground cable.
NOTE:
Global Technical Reference (GTR) lookup sequence is as follows:
GTR Home > NAS > / X150-XK / Service Information / 2007 > Workshop Manuals > Bookmark "Body and Paint/Body and Paint / 501-11
Glass Frames and Mechanisms" LINK "Door Window Motor Initialization"
2.
Refer to GTR Workshop Manual, section 501-11 and perform the door window motor initialization.
NOTE:
The fuel filler door switch must be depressed for approximately one second before the door will open. This delay prevents accidental opening.
Additionally, the vehicle must be at a standstill or moving at less than 5 km/h (3 mph) for the fuel filler door to open.
3.
Check operation of the fuel filler door.
Disclaimer