XK (X150) V8-4.2L SC (2007)
4.
Select the "Configuration Tab" and select "Module Programming" from the menu then select "Configure Existing Modules".
5.
Select and run "Software Enhancement Program".
NOTE:
The "Mirror Personalization" option is NOT to be programmed. ONLY the following modules will be reprogrammed in this Service Action:
^
Driver's door module
^
Central junction box (body control module)
^
Instrument cluster control module
^
Keyless vehicle module
^
Passenger's door module
^
Restraints control module
^
Auxiliary junction box (body control module B)
NOTE:
IDS will not remember which modules have been programmed in the "Software Enhancement Program." A good work practice is to keep a
simple check list of the above listed modules and mark each module as the software download has been completed satisfactorily.
CAUTION:
The Restraints Control Module reprogramming will launch a number of questions which can present problems for some users. Jaguar has
provided answer information in the bullets below to assist with these questions.
^
Region? - select "North America"
^
"Restraints occupant classification system (OCS)" -
>
up to VIN B09097 - select "Not fitted"
>
after VIN B09097 - select "Fitted"
^
"Is the passenger's seat track position restraints sensor fitted" - VIN between B00001 to VIN B03408 NOT listed in Table - select "Fitted"
>
VIN listed in Table - select "Not fitted"
>
VIN B03409 onward - select "Not fitted"
6.
Follow the on-screen instructions and program the modules in order shown on the screen.
7.
Disconnect the diagnostic equipment from the vehicle.