XK (X150) V8-4.2L SC (2007)
Camshaft Position Sensor: Service and Repair
Camshaft Position (CMP) Sensor LH (18.31.12)
Camshaft Position (CMP) Sensor LH (18.31.12)
Removal
1. Remove the intake air resonator.
2. Disconnect the CMP sensor electrical connector.
-
Slide the red connector latch to one side.
3. Remove the CMP sensor.
-
Remove the Torx bolt.
-
Remove and discard the O-ring seal.
Installation
1. Install the CMP sensor.
-
Clean the components.
-
Install a new O-ring seal.
-
Tighten the Torx bolt to 7 Nm (5 lb.ft).
-
Connect and secure the electrical connector.
2. Install the intake air resonator.