XK (X150) V8-4.2L SC (2007)
6.
Cut the rubber molding approximately 1 mm (0.040 in) using a suitable utility knife. (Figure 4)
CAUTION:
The filler door installation and testing must be delayed until after all software updates have been completed to avoid any electrical activity that
might disrupt IDS.
MODULE UPDATES IF SERVICE ACTION S856 HAS NOT BEEN PERFORMED
CAUTION:
The Restraints Control Module reprogramming will launch a number of questions which can present problems for some users. Jaguar has
provided answer information in the bullets below to assist with these questions.
^
Region? - select "North America"
^
Restraints occupant classification system (OCS)-
>
up to VIN B09097 - select "Not fitted"
>
after VIN B09097 - select "Fitted"
^
Is the passenger's seat track position restraints sensor fitted-
>
VIN between B00001 to VIN B03408 NOT listed in Table - select "Fitted"
>
VIN listed in Table - select "Not fitted"
>
VIN B03409 onward - select "Not fitted"
NOTE: