XK (X150) V8-4.2L SC (2007)
Headlamp Alignment Control Module: Service and Repair
Headlamp Leveling Module
Removal
1. Remove the RH side footwell heater duct.
-
Remove the 2 Torx screws.
-
Release the lamp holder.
2. Carefully release the carpet for access.
CAUTION: Make sure the wiring harness and electrical connectors are not damaged during the carpet release.
3. Remove the subwoofer cover.
-
Remove the 4 bolts.
4. Remove the headlamp leveling module.
-
Remove the 2 bolts.
-
Disconnect the electrical connector.
Installation
1. Install the headlamp leveling module.
-
Connect the electrical connector.
-
Tighten the bolts to 3 Nm (2.2 lb.ft).
2. Install the subwoofer cover.
-
Tighten the bolts to 10 Nm (7 lb.ft).
3. Install the carpet.
CAUTION: Make sure the carpet is correctly installed and that no foul-condition exists when the accelerator pedal is depressed.
4. Install the RH side footwell heater duct.
-
Install the Torx screws.
-
Install the lamp holder.