XK (X150) V8-4.2L SC (2007)
Refrigerant Pressure Sensor / Switch: Service and Repair
Pressure Cutoff Switch (82.10.32)
Removal
1. Remove the cover and disconnect the battery ground cable.
2. Recover the A/C refrigerant.
3. Remove the engine cover.
4. Remove the air intake duct.
-
Remove the bolt.
-
Release the 2 clips.
5. Remove the pressure cutoff switch.
-
Disconnect the electrical connector.
-
Remove and discard the O-ring seal.
CAUTION: Before disconnecting or removing components, ensure the area around the joint faces and connections are clean. Plug open
connections to prevent contamination.
Installation
1. Install the pressure cutoff switch.
-
Clean the components.
-
Install a new O-ring seal.
-
Tighten the cutoff switch to 10 Nm (7 lb.ft).
-
Connect the electrical connector.
NOTE: Lubricate the O-ring seals with clean refrigerant oil.
2. Install the air intake duct.
-
Tighten the clips.
-
Tighten the bolt to 10 Nm (7 lb.ft).
3. Recharge the A/C system.
4. Install the engine cover.
5. Connect the battery ground cable and install the cover.