XK (X150) V8-4.2L SC (2007)
Wiring Harness: Removal and Replacement
Engine Wiring Harness - Vehicles With: Supercharger
Removal
1. Remove the cover and disconnect the battery ground cable.
2. Raise and support the vehicle.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
3. Remove the intake air resonator.
4. Remove the engine control module (ECM).
5. Recover the A/C refrigerant.
6. Remove the fan cowl.
-
Remove the 15 clips.
7. Release and disconnect the engine wiring harness electrical connector.
-
Fully loosen the bolt.
8. Release the ground cable from the power distribution box bracket.
-
Remove the nut.
9. Release the engine wiring harness from the engine compartment side wall.
-
Release the grommet.