XK (X150) V8-4.2L SC (2007)
/v8-4.2l_sc/Page-1010002.png)
Installation
1. Using the special tool, compress the spring to install the shock absorber.
^
Passive shock absorber: Tighten the nut to 27 Nm (20 lb.ft).
^
Active shock absorber: Tighten the nut to 50 Nm (37 lb.ft).
2. Install the shock absorber and spring assembly.
^
Tighten the nuts to 27 Nm (20 lb.ft).
^
Tighten the bolt to 133 Nm (98 lb.ft).
^
Active shock absorber: Connect the electrical connector.
3. Install the LH rear wheel and tire.
4. Install the loadspace trim panel.
5. Using only four-wheel alignment equipment approved by Jaguar, check and adjust the wheel alignment.
