XK (X150) V8-4.2L SC (2007)
/v8-4.2l_sc/Page-1012004.png)
Installation
1. Install the wheel bearing.
^
Tighten the bolts to 70 Nm (52 lb.ft).
2. Install the knuckle assembly.
3. NOTE: Tighten the nut to 90 Nm (66 lb.ft).
Do not fully tighten the locking nut at this stage.
Install the halfshaft.
^
Tighten the old nut.
4. CAUTION: The final tightening of the suspension components must be carried out with the vehicle on its wheels.
Install the lower arm nut and bolt.
^
Tighten the nut and bolt to 150 Nm (110 lb.ft).
5. CAUTION: The final tightening of the suspension components must be carried out with the vehicle on its wheels.
Connect the toe link.
^
Tighten the nut and bolt to 55 Nm (40 lb.ft).
6. Install the wheel speed sensor.
^
Install the bolt and tighten to 10 Nm (7 lb.ft).
7. Install the brake disc.
8. Install the brake caliper.
^
Secure the clips.
^
Tighten the bolts to 103 Nm (76 lb.ft).
9. Install the wheel and tire assembly.
10. Remove the old halfshaft nut and install the new one, tighten to 300 Nm (222 lb.ft)
^
Install the wheel trim.
11. Install the wheel trim.
