XK (X150) V8-4.2L SC (2007)
/v8-4.2l_sc/Page-758001.png)
Fluid Pan: Service and Repair
Transmission Fluid Pan, Gasket and Filter
Removal
1. Disconnect the battery ground cable.
2. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
3. Drain the transmission.
4. Remove the fluid pan.
^
Position a container to collect the fluid spillage.
^
Remove the 21 Torx screws.
^
Remove and if necessary, discard the seal.
^
Discard the O-ring seal.
Installation
1. Install the fluid pan.
^
Clean the components.
^
Install the seal.
^
Install a new O-ring seal.
^
Tighten the Torx screws to 8 Nm (6 lb.ft).
2. Connect the battery ground cable.
3. Refill the transmission with fluid.
