XK (X150) V8-4.2L SC (2007)
Removal
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the cover and disconnect the battery ground cable.
3. Remove the driveshaft.
4. Release the transmission support insulator.
5. Using the special tool, to hold the output flange, remove the retaining nut.
^
Discard the nut.
6. Using the special tool, remove the output flange.
7. Using the special tools, remove the extension housing seal.
Installation
1. Using the special tool, install a new extension housing seal.
^
Clean the component mating faces.