XK (X150) V8-4.2L SC (2007)
Shifter A/T: Service and Repair
Selector Lever Cable and Bracket
Selector Lever Cable and Bracket
Removal
1. Remove the floor console.
2. NOTE: Connect a line to the transmission selector cable to aid installation.
Release the transmission selector lever cable.
^
Release the gaiter.
^
Pass the gear selector cable through the vehicle floor.
^
Tie the recovery line to the floor console ground nut.
3. Raise and support the vehicle.
4. Release the exhaust heat shield for access.
^
Remove the 4 bolts.
5. Position the LH side transmission casing heat shield aside.
^
Remove the 2 bolts.
6. Remove the selector cable and bracket.
^
Carefully disconnect the selector cable ball joint.
^
Remove the 2 bolts.
^
Withdraw the cable.