XKR Convertible (X100) V8-4.0L SC (AJ27) (2001)
15. Fit crossbeam front mounting-brackets.
1. Align mounting bracket to crossbeam.
2. Fit front bolts: do not tighten at this stage, (one bolt on convertible vehicles).
3. Fit and tighten rear bolt.
4. Tighten front bolts.
-
Repeat procedure to fit opposite-side mounting bracket.
16. Lower and remove jack from underneath crossbeam.
17. NOTE: Make sure steering wheel and wheels are in the central position before fitting steering column.
Fit steering column to pinion shaft.
-
Move column downwards onto pinion shaft.
1. Fit and tighten bolt.
18. Remove blanking plugs from PAS hoses and pinion housing ports.
19. Connect return hose to pinion shaft housing.
-
Apply clean PAS fluid to a new O-ring and fit to hose.
-
Connect and fully seat hose.
20. Connect feed hose to pinion shaft housing.
-
Apply clean PAS fluid to a new O-ring and fit to hose.
-
Connect and fully seat hose.