XKR Coupe (X100) V8-4.0L SC (AJ27) (2000)
Door Glass Lift Switch Veneer Panel
Removal
1. Remove battery cover and disconnect ground cable from battery terminal. Refer to 'Battery, Battery Cable.' See: Starting and
Charging/Battery/Battery Cable/Negative
2. Remove glass lift switch.
Remove glass lift switch end cover trim pad.
Remove the switch securing screw.
3. Disconnect the switch harness multiplug.
4. Release veneer panel clips.
Installation
1. Install veneer panel on switch ensuring retaining clips are fully seated.
2. Connect harness multiplug to switch.