XKR Coupe (X100) V8-4.0L SC (AJ27) (2000)
7. Release tie-rod end from steering arm.
1. Fit special tool to tie-rod end.
2. Tighten tool bolt to release tie-rod end, taper pin.
3. Remove tool and disengage tie-rod end from steering arm.
8. Remove nut from upper-wishbone ball joint.
CAUTION: Do not allow the weight of the vertical link to hang on the lower ball joint, after releasing the upper ball joint.
9. Release upper-wishbone ball joint from vertical link.
1. Fit special tool to ball joint.
2. Tighten tool bolt to release ball joint taper-pin.
3. Remove tool and disengage ball joint from vertical link.