XKR Coupe (X100) V8-4.0L SC (AJ27) (2000)
7. Apply 'Alphabond Rapid 101' epoxy adhesive to the shaded area of the bush (as shown), and corresponding area of the bush-housing bore.
8. CAUTION: Bush alignment error must not exceed 5 degrees.
Aligning bush with subframe.
-
Position bush with large single void facing forward.
-
Align small void centers with masking tape markers.
9. Install bush in housing.
-
Position a steel plate over the bush, ensuring the plate is large enough to cover the rubber flange.
-
Operate the press to install the bush.
10. Ensure bush is fully seated in subframe.
-
The clearance between the bush flange and subframe must not exceed 1.5 mm.
11. Ensure bush is aligned correctly in subframe as detailed in Step 8 or 9 as appropriate.
12. Wipe off excess adhesive from subframe and bush, and remove masking tape.