XKR Coupe (X100) V8-4.0L SC (AJ27) (2000)
10. Remove the linear switch.
Remove the four screws.
Remove the linear switch from the mounting bracket.
Installation
1. Install the linear switch.
Position the linear switch to the mounting bracket.
Align the drive peg and lower sliding block of the switch to the mating components of the selector mechanism.
2. Install the four screws, but do not fully tighten.
Remove the Tie-Strap from the dual linear switch.
Use the manual release and reposition the selector to 'N' for installation of the selector cable.
3. Connect the electrical connector to the linear switch.