Cherokee 2WD L4-126 2.1L DSL Turbo VIN B FI (1986)
Neutral Safety Switch: Testing and Inspection
NEUTRAL START CIRCUIT
Neutral Start And Backup Lamp Switch
1. Remove the wiring connector from the switch (1) and test for continuity between the center terminal pin and the transmission case. Continuity
should exist only when the transmission is in Park or Neutral.
2. If the tests indicate that the switch may be defective, check the gearshift linkage adjustment before replacing the switch.
3. Remove the switch from the transmission. Allow the transmission fluid to drain into the container.
4. Move the gearshift lever to Park (2) and Neutral (3) positions. Inspect the switch operating lever fingers and the manual lever and shaft for proper
alignment with the switch opening in the case.
5. Install the switch and the switch seal in the transmission case. Tighten the switch with 35 Nm (24 ft. lbs.) torque.
6. Test the switch continuity.
7. Correct the transmission fluid level as required. Refer to Fluid Level and Condition for the refill procedure.
See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Procedures
