Cherokee 2WD L4-126 2.1L DSL Turbo VIN B FI (1986)
Band: Adjustments
Front Band Adjustment
FRONT BAND ADJUSTMENT
The front band adjusting screw is located on the left side of the transmission case just above the manual valve and throttle control levers.
Perform the adjustment by proceeding in the following manner:
1. Raise the vehicle.
2. Loosen the adjusting screw locknut and back off the locknut five turns.
3. Check the adjusting screw rotation. The screw must turn freely in the case. Lubricate the adjusting screw threads if the screw binds.
Front Band Adjustment
4. Tighten the adjusting screw with 4 Nm (36 in. lbs.) torque using Torque Wrench J-5853-B, Adapter Tool J-24063 and a 5/16 square socket.
CAUTION: If the Adapter Tool J-24063 is not used, the band adjusting screw must be tightened with 8 Nm (72 in. lbs.) torque.
5. Back off the adjusting screw 2-1/2 turns.
6. Tighten the adjuster screw locknut with 47 Nm (35 ft. lbs.) torque. Do not allow the adjuster screw to rotate when tightening the locknut.
7. Lower the vehicle.
