Cherokee 2WD L4-126 2.1L DSL Turbo VIN B FI (1986)
16.
Disconnect the ignition interlock cable from the floor shifter bellcrank and shifter bracket (Figure 5).
17.
Disconnect the ignition interlock cable from the ignition key cylinder (Figure 4).
18.
Remove and discard the ignition interlock cable by pulling it under and through the carpet.
19.
Remove the existing tie strap from the new interlock cable solenoid.
20.
Install the new interlock cable under the carpet and route in the same general location as the old cable.
21.
Connect the cable to the floor shifter bracket and shifter (Figure 5).
22.
Connect the cable to the ignition key cylinder (Figure 4).
23.
Re-install the steering column.
24.
Connect all cable mounting clips (Figure 4).
25.
Secure the cable solenoid to the steering column with 2 of the provided tie straps.
26.
Install the carpeting.
27.
Install the accelerator pedal assembly after routing and clipping cable (Figure 4).
28.
Turn the ignition key to the ACC (accessory) position.
29.
Ensure that the floor shifter is in the PARK position.
30.
Remove the shipping pin from the cable ignition key lock cylinder fitting (Figure 4).
