Cherokee 2WD L4-126 2.1L DSL Turbo VIN B FI (1986)
20.
Disconnect the ignition interlock cable from the ignition key cylinder (Figure 15).
21.
Remove and discard the interlock cable by pulling it under and through the carpet.
22.
Remove the tie strap from the solenoid on the new cable.
23.
Install the new interlock cable under the carpet and route in the same general location as the old cable.
24.
Connect the cable to the floor shifter bracket and shifter (Figure 16).
25.
Connect the cable to the ignition key cylinder (Figure 15).
26.
Re-install the steering column and pencil braces.
27.
Secure the cable solenoid to the steering column with two (2) of the provided tie straps.
28.
Turn the ignition key to the ACC (accessory) position.
29.
Ensure that the floor shifter is in the PARK position.
30.
Remove the shipping pin from the cable ignition key lock cylinder fitting (Figure 15).
31.
Compress and release the spring loaded cable adjuster (Figure 17).
32.
Press the interlock cable lock clamp down until it snaps into place (Figure 17).
33.
Install the steering column upper and lower shrouds (Figure 13).
34.
Install the steering column tilt lever, if equipped.
35.
Disconnect the brake pedal switch 6-way wiring connector.
36.
Connect the brake switch wiring connectors to their mating halves on the supplied wiring harness.
37.
Connect the wiring harness WHITE 2 way connector to the solenoid on the new shift interlock cable.
