Cherokee 2WD L4-126 2.1L DSL Turbo VIN B FI (1986)
28.
Connect the cable to the ball stud on the steering column as follows (Figure 27):
^
For 1991-1994 model year vehicles: Turn the ignition key to the ON position to energize the solenoid and extend the ball stud rod. Push the
ball stud rod back up under the steering column shroud and then attach the cable fitting to the ball stud while holding the stud in position.
Make sure the ball stud is bottomed out.
^
For 1984-1990 model year vehicles: Turn the ignition key to the ACCESSORY position. Connect the cable fitting to the ball stud. Make sure
the ball stud is bottomed out.
29.
Turn the ignition key to the LOCK position.
30.
Tighten the steering column bracket mounting nut to 35 in-lbs (4 N.m) (Figure 23).
31.
Install the steering column and pencil braces.
32.
Connect the cable to the floor shifter bracket and shifter (Figure 24).
33.
Turn the ignition key to the ON position.
IMPORTANT:
The solenoid must be energized for proper cable adjustment.
34.
Ensure that the floor shifter is in the PARK position.
35.
Compress and release the spring loaded cable adjuster (Figure 28).
