Cherokee 2WD L4-126 2.1L DSL Turbo VIN B FI (1986)
IMPORTANT:
The mounting hole for the cable in the bracket is not square. Therefore, the bracket must be installed with the cable locking tabs oriented as
shown.
20.
Install the new interlock cable under the carpet and route in the same general location as the old cable.
21.
Connect the cable bracket to the steering column stud. Allow the bracket to slide.
IMPORTANT:
Do NOT connect the cable to the steering column ball stud until after the solenoid wiring harness has been installed.
22.
FOR 1991 - 1994 MODEL YEAR VEHICLES:
A.
Disconnect the brake pedal switch 6-way wiring connector.
B.
Connect the brake switch wiring connectors to their mating halves on the new wiring harness.
23.
FOR 1984 - 1990 MODEL YEAR VEHICLES:
A.
Disconnect the brake pedal switch 2-way wiring connector.
B.
Connect the 2-way brake switch connector on the supplied harness to the brake switch.
C.
Connect the BLUE and PINK wires from the harness to the appropriate terminal on the brake switch connector that was removed in Step
23A (i.e. matching wire color).
24.
Connect the wiring harness WHITE 2-way connector to the solenoid on the new shift interlock cable.
25.
Connect the wiring harness solenoid feed connector to the fuse box as follows:
^
FOR 1991 - 1994 MODEL YEAR VEHICLES: Insert the BROWN wiring harness single wire connector into the fuse block IGNITION FEED
location marked "IGN (Figure 26).
^
FOR 1984 - 1990 MODEL YEAR VEHICLES: Insert the GREEN wiring harness single wire connector to the fuse block ACCESSORY
FEED location marked ACC (Figure 26).
26.
FOR 1984-1990 MODEL YEAR VEHICLES: Connect the harness ground eyelet to the first screw on the lower instrument panel reinforcement
located just to the left of the center console.
27.
Secure the new wiring harness and cable solenoid to the instrument panel wiring harness with the provided tie straps.
