Cherokee 2WD L4-126 2.1L DSL Turbo VIN B FI (1986)
Valve Body: Adjustments
Line Pressure Adjustment
Line Pressure Adjustment
Line Pressure Adjustment
Measure the distance from the valve body to the inner edge of the adjusting screw (1) using an accurate steel scale. The distance measured (2)
should be 33.4 mm (1-5/16 in).
If an adjustment is required, turn the adjusting screw in or out to obtain a 33.4 mm (1-5/16 in) setting.
NOTE: The 33.4 mm (1-5/16 in) setting is an approximate setting. Because of manufacturing tolerances, it may be necessary to vary from this
dimension to obtain the desired pressure. One complete turn of the adjusting screw changes the line pressure approximately 9 kPa (1-2/3 psi).
Turning the adjusting screw counterclockwise increases pressure whereas turning the screw clockwise decreases pressure.
