Cherokee 2WD L4-150 2.5L VIN E TBI (1989)
Evaporator Housing Alignment Tab
Evaporator Housing Installation
1. Position the evaporator/blower housing into place, being sure to line up the housings using the provided alignment tabs.
2. Install the housing retaining screws and the rear housing clip.
CAUTION: When installing the evaporator/blower housing, care must be taken so as not to trap wires between the housing fresh air inlet and the dash
panel on the right side of the housing
3. Install the housing retaining nuts on the engine compartment side of the dash panel.
4. Connect the A/C hoses to the expansion valve and connect the heater blower motor wires.
5. Attach the wire connections at the blower motor resist6rs and the A/C thermostat.
6. Connect the vacuum hose at the vacuum motor and attach the heater control cable.
7. Install the instrument panel bolt and the kick panel.
8. Install the lower instrument panel and screws.
9. Install the console (if equipped).
10. Connect the battery negative cable.
11. Evacuate and charge the A/C system as lined in this section.
12. Start the vehicle and check for proper operation at all vacuum motors.
EVAPORATOR CORE REPLACEMENT
