Cherokee 2WD L4-150 2.5L VIN H TBI (1988)
Front Door Weatherstrip: Service and Repair
MOLDINGS AND WEATHERSTRIPS
Exterior Moulding Replacement
To remove the two-piece window exterior molding, roll the window down. Then carefully pull and pry the molding halves from the door flange.
To install the moldings, start at the forward end of the top molding. Press the molding onto the door flange and continue work rearward until the
molding is seated. Engage the rear molding with the top molding and press the molding edge in to start it. Then continue downward to complete
installation.
Replacing Glass Channel Weatherstrip
The glass channel weatherstrip can be removed by hand or with the aid of a small putty knife or similar tool. To install a new weatherstrip, start at
the upper corner. Then work forward and down evenly until the weather strip is fully seated in the frame. A small amount of adhesive can be used
to hold the weatherstrip in position if desired.
The front door weatherstrip is attached to the periphery of the door opening in the body. The weatherstrip is secured with adhesive and plastic
push studs. The push studs can be removed with the same type of tool used to remove the fender liner push rivets. Use adhesive along with the
