Cherokee 2WD L4-150 2.5L VIN H TBI (1988)
5.
Remove the voltmeter positive lead from terminal A and connect it to terminal B. The "output" voltage should be 0.2 volts (4% of input voltage).
If this is not the case, continue with this procedure.
6.
Adjust output voltage as follows: with the voltmeter leads still attached, carefully loosen the sensor mounting screws and slowly rotate the sensor
until the output reading is 0.2 volts with the throttle wide open. Then, tighten the sensor mounting screws securely. Be sure not to disturb the
sensor's position while tightening the screws. Adjustment is now complete.
POLICY:
Information only
