Cherokee 2WD L4-150 2.5L VIN H TBI (1988)
Fig.19 Adjusting Sensor Air Gap
b) Set sensor-to-tone wheel air gap at 0.33 - 0.48 mm (0.013 - 0.019 inch) with brass feeler gauge.
c) Tighten sensor bolt to 14 Nm (11 ft. lbs.) torque and recheck spacing.
8. Secure sensor wire to brake line and steering knuckle with new tie straps.
Rear
Fig.20 Rear Sensor Connectors
REAR SENSOR REMOVAL
1. Raise and fold rear seat forward for access to rear sensor connectors.
2. Disconnect sensors at harness connectors.
3. Push sensor grommets and sensor wires through floorpan.
4. Raise vehicle.
5. Remove wheel and brake drum.
